4.4
2,100+ reviews on G2
Actual yield is the amount of product a reaction really gives, measured in the lab, and it is often less than the theoretical yield calculated from the balanced equation. You work with three quantities:

The most product the equation allows.
What you weigh after the reaction.
Actual ÷ theoretical × 100%.
Grams with grams, or moles with moles.
Do your homework in Evernote. The AI Assistant explains any problem you photograph, step by step.
The mole ratio between reactant and product comes from the coefficients.
Divide its mass by its molar mass. If there are two reactants, find the limiting one first.
Use the mole ratio to get moles of product, then multiply by the product's molar mass.
Weigh the dry product you collected. That mass is the actual yield.
Percent yield = actual yield ÷ theoretical yield × 100%. If a problem gives the percent yield instead, actual yield = percent yield ÷ 100 × theoretical yield.
Heating 25.0 g of CaCO₃ gives CaO and CO₂. You collect 12.6 g of CaO. Find the theoretical and percent yield.
Theoretical yield 14.0 g; actual yield 12.6 g; percent yield 90.0%
Working backward: if the percent yield were 85.0%, the actual yield would be 0.850 × 14.0 g = 11.9 g.
The three are linked by one formula, so knowing any two gives you the third.
| Yield | Where it comes from | Formula |
|---|---|---|
| Theoretical | Stoichiometry of the balanced equation | moles of limiting reactant × ratio × molar mass |
| Actual | Measured in the lab | actual = percent ÷ 100 × theoretical |
| Percent | Compares the two | percent = actual ÷ theoretical × 100% |
OpenStax Chemistry 2e, section 4.4 "Reaction Yields"; atomic masses from the OpenStax Chemistry 2e periodic table.
4.4
2,100+ reviews on G2
4.4
8,200+ reviews on Capterra
4.4
73,000+ reviews on App Store
248M
Registered users
The amount of product actually obtained from a reaction. It is measured, not calculated, unless a problem gives you the percent yield and the theoretical yield.
Some reactions have side reactions or do not go to completion, and some product is lost while collecting it. Each of these lowers the amount you recover.
A percent yield above 100% means the measured mass is larger than the theoretical yield, so check for a wet product, impurities, or a measuring error.
Multiply the theoretical yield by the percent yield as a decimal. 75% of 20.0 g is 0.75 × 20.0 = 15.0 g.
The reactant that runs out first. It sets the theoretical yield, so compare the moles of product each reactant could make and use the smaller.
No, but both must use the same unit. Moles, grams or, for gases, volume all work, because the units cancel in the percent.
Keep a Math notebook with your chemistry formula sheet and a note for each problem you photograph.
Ask the AI Assistant to add the percent yield formula to your chemistry formula sheet, with one worked example. It writes the formula in a formula block, so it reads like the textbook.
Add a photo of your chemistry problem, such as the calcium carbonate yield problem, and ask the Assistant to explain it step by step. It reads the photo and adds the steps under it.
Ask the Assistant for a repeating practice task, such as 10 percent yield problems every Tuesday and Thursday until the test. You get a reminder each time.
Build a formula sheet, photograph a problem for a step-by-step explanation, and practice on a schedule before the test.
Start for free