4.4
2,100+ reviews on G2
Cleaning a dishwasher means clearing the filter, the spray arms and the door seal, then running an empty hot cycle with a cleaner to remove grease and mineral buildup. Whirlpool says to clean the filter about once a month. Four things to check:

Food caught in the filter can cause smells and gritty dishes. Rinse it once a month.
Blocked holes leave dishes dirty. Clear them with a toothpick or a paper clip.
Grime collects in the rubber gasket and the door edges. A soft toothbrush reaches it.
A dishwasher cleaner or a cup of white vinegar removes grease and hard-water film.
Keep your chores in Evernote. Let the Assistant read the manual and set a repeating task.
Take out the racks if they slide out easily. Pick out food, glass chips and labels from the bottom of the tub and around the drain with a damp paper towel.
On many models you turn the upper filter a quarter turn counterclockwise, lift it out, then pull the lower filter forward. Rinse both under warm running water. Scrub stuck food or hard-water deposits with a soft brush, never a wire brush or a scouring pad.
Spin each arm by hand. If the holes look blocked, push the bits out with a toothpick or a paper clip, as GE suggests. On removable arms, check your manual before taking them off.
Wipe the inside of the door, its edges and the control panel with a damp microfiber cloth. Clean the rubber gasket with a soft toothbrush, without pulling on the seal.
Use a dishwasher cleaner, or put a dishwasher-safe cup with 2 cups of white vinegar upright on the bottom rack and run a full hot cycle with no detergent. Vinegar is an acid, so KitchenAid advises using it only for a deep clean and checking your manual first.
Put the filter back and turn the upper part until it locks. Never run the dishwasher without the filter in place. Write down the date, so you know when the next cleaning is due.
Check your manual first: some models have a self-cleaning filter, and some advise against vinegar.
Intervals from manufacturer care guides. Clean more often if you run the dishwasher every day, have hard water or notice a smell.
| Part | How often | Signs it is due |
|---|---|---|
| Filter | Once a month (every 2 weeks with daily use) | Smell, food left on dishes, gritty feel |
| Bottom of the tub and drain | After a load that leaves debris | Bits of food or glass you can see |
| Spray arms | When you clean the filter | Dirty dishes on one rack, blocked holes |
| Door, edges and gasket | Once a month | Grime or film on the seal |
| Cleaning cycle (cleaner or vinegar) | Monthly with a cleaner, every few months with vinegar | Cloudy glasses, white film, grease |
Sources: Whirlpool, "How to Clean the Dishwasher Filters"; GE Appliances, "How to Clean Your Dishwasher"; KitchenAid, "How to clean and deodorize a dishwasher".
One card per chore. Copy it, or save it to your Evernote account and keep it next to the manual.
Chore: Clean the dishwasher
How often: Filter once a month
Takes: [minutes]
You need: [supplies]
Steps:
1. [first step]
2. [next step]
Model number: [from the label on the appliance]
Last done: [date] ยท Next due: [date]
4.4
2,100+ reviews on G2
4.4
8,200+ reviews on Capterra
4.4
73,000+ reviews on App Store
248M
Registered users
About once a month, according to Whirlpool and KitchenAid. If you run the dishwasher every day or have a large household, Whirlpool suggests every two weeks. Some models have a self-cleaning filter that never needs it: your manual says which kind you have.
Whirlpool says the filter is usually positioned at the bottom of the dishwasher. Take out the bottom rack to reach it.
Yes, for an occasional deep clean. Put 2 cups of white vinegar in a dishwasher-safe cup on the bottom rack and run a full cycle with no detergent. Vinegar is an acid and can damage some parts if used too often, so check your manual first.
Yes. KitchenAid suggests sprinkling 1 cup of baking soda on the bottom of the empty dishwasher and running a short hot cycle. It helps with stains and odors.
Food trapped in the filter or the drain, and water standing between loads, can cause smells. Clean the filter, clear the drain area and run a cleaning cycle. If you run it only every few days, scrape and rinse dishes before loading.
A film from hard-water minerals. A dishwasher cleaner removes the buildup, and keeping the rinse aid dispenser full helps prevent it. KitchenAid recommends a water softener if your water hardness is 15 grains or more.
No. Whirlpool warns not to run it without the filters properly installed, because food and debris can damage the pump. Make sure the upper filter is locked: if it turns freely, it is not.
Wipe the door, sides and handle with a soft damp cloth and mild detergent, or a stainless steel cleaner. Wipe in the direction of the grain and avoid abrasive cleaners, which scratch the finish.
Keep one note per chore in a Home notebook, and let tasks bring each chore back when it is due.
Attach the manual's PDF to the chore note and ask the AI Assistant how to clean the filter. It reads the PDF and adds the steps to the note as a checklist.
Ask the AI Assistant for a task that repeats on the first Saturday of every month. It comes with a reminder on the day it is due.
Open the Tasks view to see what is due in the next 7 days and later. Assign a task to anyone you share the note with.
Keep the steps with the manual, let each chore repeat on its own, and see everything that is due in one list.
Start for free